The MM1 is a computer-controlled machine that automates the cutting of profiles, holes and shapes on pipe with diameters from 4" to 16" (10-40 cm). It rotates the pipe on it’s roller bed with a three jaw chuck while simultaneously moving a cutting torch back and forth along the pipe’s axis. Pre-programmed shapes such as saddle, hillside, lateral and miter cuts can be made. In addition irregular or uncommon shapes can be plotted, programmed and saved for future use.
The SE-2 Programmable Pass Through Machine provides single or dual programming capabilities. The SE-2 has a single program for making Saddle Cuts, Offset Cuts, Laterals and Miters. This machine also has a second (selectable) program for cutting holes and shapes in pipes. Pipes from 4" (100 mm) to 14" (355 mm) can be chucked internally and pipes from 1" (25 mm) to 4" (100 mm) can be chucked using the pass through option. The SE-2 Machine is suitable for plasma and oxy-fuel cutting and eliminates the need to make templates or layout complex cuts.
The SE-4P is a programmable machine, similar to the SE-4. It will cut saddles, laterals, miters, offsets (hillsides) and elbows using a micro-processor and handheld terminal. Oxyfuel or Plasma may be used. Cutting diameter 1"-12" (25-300 mm). (Maximum length of pipe to be cut, 18" [450 mm]). SE-4P maximum rotation speed is 3.7 rpm, which is 47 ipm (1160 mm/min) on 4" (100 mm) O.D.’s.